Not only were the ceilings high, in some rooms they were coved at the perimeter and had decorative cornice or picture mold. The home was Mediterranean-style construction, plaster in and out, with spacious rooms and high ceilings. You also might recall that we grew up in a home built by our grandfather at the turn of the 20th century. Reconnect the wires using approved wire connectors, reinstall the canopy and turn on the power.If you regularly read our column you know that we are third-generation contractors. Due to the added ceiling thickness, longer screws and/or threaded tubing might be needed to properly anchor the light fixture. Once the caulk has dried, the medallion is ready for paint.įor best results, prime the medallion with an oil-base primer and finish with one or more coats of latex in the color of your choice.Ĭomplete the job by reinstalling the light fixture. As you would with paneling nails, countersink the construction screws and conceal with a patching compound.Īpply a bead of caulk at the perimeter of the medallion and smooth, using your finger or a damp sponge. Instead of paneling nails, the medallion can be fastened to the ceiling using construction screws. ![]() Later, countersink the nails using a nail punch, and conceal the nail heads with spackling. Use four 15/8-inch paneling nails equally spaced on the medallion to hold it in place while the adhesive sets up. Place the medallion into position on the ceiling immediately after applying adhesive. Next, apply a minimum of a 1/2-inch bead of adhesive along the outside edge on the underside of the ceiling medallion. The hole should be large enough to allow wiring and one or more threaded bolts to pass through, yet small enough to be completely covered by the fixture canopy. Place the ceiling medallion upside-down and cut a hole in the center, using a drill or fine-tooth saw. Use the opportunity while the fixture is down to give it a good cleaning and polishing. Lower the fixture canopy and carefully disconnect the wires. With the power off, carefully remove the light fixture-usually held in place with a couple of screws or a nut on a short length of threaded tubing. Don’t rely on the light switch the power for the light might originate at the fixture rather than the switch. ![]() Begin by turning off the power to the light fixture at the breaker panel or fuse box. ![]() When installing a ceiling medallion where a light fixture exists, the fixture must be removed and reinstalled after the medallion installation is completed. In either case, it is easy to install one. And although a decorative ceiling medallion is often used as a “rosette” or foil for a chandelier, it is equally popular as a focal point of a room’s ceiling. You can have a hexagon, an octagon or even a star. They can be round, square, oval, rectangular or triangular. Ceiling medallions come in various shapes and sizes. For dressing up a ceiling, decorative medallions are reasonably priced, easy to install and attractive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |